Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Please read all instructions carefully before assembly, installation and/or use of this product.
WARNING: The Maximum capacity is 400 pounds. DO NOT EXCEED lowest of: vehicle mfg's, hitch weight carry
tongue weight, or cargo basket rating. Use with class 3 or higher 2" receiver hitch.
WARNING: Keep all body parts away from ramp sections when opening and closing ramp.
WARNING: Not for transport of people, animals, or flammable liquids.
WARNING: Do not ride equipment up ramp.
WARNING: Do not lubricate threads. Bolt failure may occur due to over tightening.
WARNING: Do not drill or weld to this product.
SPRING CLIP DETAIL
4
1
Qty. (1)
Latch Arm
2
Qty. (5)
Hex Bolt, 3/8-16 x 1.00 Gr5
3
Qty. (5)
Hex Locknut, 3/8-16
4
Qty. (1)
Spring Clip
5
Qty. (2)
Screw, Self-Tapping #8
NOTE: This ramp is designed for use with cargo basket 1040100.
ASSEMBLY INSTRUCTIONS:
1.
Attach the two halves of ramp with the 3/8 hex bolts and locknuts as shown above.
2.
Tighten 3/8 bolts until snug and ramp sections swing freely.
WARNING: DO NOT PLACE ANY BODY PARTS BETWEEN RAMP SECTIONS WHEN OPENING OR CLOSING RAMP.
3.
Install the lock pin, coil spring, flat washer, and lock nut into hole on side of ramp as shown.
4.
Tighten the 1/4-20 locknut until there is approximately 5/8" between the flat washer and ramp tube – see lock pin detail.
5.
Attach the spring clip in orientation shown using two #8 self-tapping screws – see spring clip detail.
All manuals and user guides at all-guides.com
7 8 9
5
Item:
Description:
2 3
6
6
Qty. (1)
Lock Pin
7
Qty. (1)
Coil Spring
8
Qty. (1)
Flat Washer, 1/4
9
Qty. (1)
Hex Locknut, 1/4-20
1040200
CARGO RAMP
TOOLS REQUIRED:
7/16 Wrench
9/16 Wrench
Phillips Screw driver #2
5/8"
LOCK PIN DETAIL

Publicité

loading

Sommaire des Matières pour Reese PRO Serie

  • Page 1 All manuals and user guides at all-guides.com Item: 1040200 CARGO RAMP Description: Please read all instructions carefully before assembly, installation and/or use of this product. WARNING: The Maximum capacity is 400 pounds. DO NOT EXCEED lowest of: vehicle mfg’s, hitch weight carry tongue weight, or cargo basket rating.
  • Page 2 All manuals and user guides at all-guides.com Item: 1040200 CARGO RAMP Description: RAMP END RAIL Latch Hole FIGURE 1 Ramp Hole Ramp Hinge WARNING: DO NOT PLACE ANY BODY PARTS BETWEEN RAMP SECTIONS WHEN OPENING OR CLOSING RAMP. ASSEMBLY INSTRUCTIONS: Remove the end rail from cargo basket.
  • Page 3 All manuals and user guides at all-guides.com Item: 1040200 CARGO RAMP Description: Please read all instructions carefully before assembly, installation and/or use of this product. TIE EQUIPMENT DOWN TO CARGO BASKET LATCH ARM LOCK PIN SPRING CLIP HANDLE FIGURE 2 WARNING: DO NOT PLACE ANY BODY PARTS BETWEEN RAMP SECTIONS WHEN OPENING OR CLOSING RAMP.
  • Page 4 All manuals and user guides at all-guides.com Item: 1040200 RAMPE DE CHARGEMENT Description: Veuillez lire toutes les instructions attentivement avant l’assemblage, l’installation et/ou l’utilisation de ce produit. AVERTISSEMENT : La capacité maximale est de 400 livres (136 kg). NE DÉPASSEZ PAS la moins élevée des charges maximales suivantes : spécifiée par le fabricant du véhicule, au timon d'attelage ou sur le panier porte-bagages.
  • Page 5 All manuals and user guides at all-guides.com Item: 1040200 RAMPE DE PORTE-BAGAGES Description: Veuillez lire attentivement toutes les instructions avant l’assemblage, l’installation et/ou l’utilisation de ce produit. BOULON HEX. 3/8-16 x 1.00 GR5 CONTRE-ÉCROU 3/8 TROIS (3) ENDROITS BRAS DE RAMPE VERROUILLAGE PROFILÉ...
  • Page 6 All manuals and user guides at all-guides.com Item: 1040200 CARGO RAMP Description: Veuillez lire attentivement toutes les instructions avant l’assemblage, l’installation et/ou l’utilisation de ce produit. FIXER L’ÉQUIPEMENT AU PORTE-BAGAGES BRAS DE VERROUILLAGE TIGE DE VERROUILLAGE ATTACHE À RESSORT POIGNÉE FIGURE 2 AVERTISSEMENT : NE PLACEZ AUCUNE PARTIE DU CORPS ENTRE LES SECTIONS DE RAMPE LORS DE L'OUVERTURE OU LA FERMETURE DE LA RAMPE.
  • Page 7 All manuals and user guides at all-guides.com Item: 1040200 RAMPA DE CARGA Description: Lea atentamente todas las instrucciones antes de armar, instalar y/o usar este producto. ADVERTENCIA: La capacidad máxima es 400 libras. NO SUPERE EL VALOR INFERIOR ENTRE: la calificación del fabricante del vehículo, el peso de la horquilla de carga del enganche o la calificación de la canasta de carga.
  • Page 8 All manuals and user guides at all-guides.com Item: 1040200 RAMPA DE CARGA Description: Lea atentamente todas las instrucciones antes de armar, instalar y/o usar este producto. 3/8-16 x 1.00 GR5 Perno hexagonal Tuerca de bloqueo 3/8 (3) lugares BRAZO PASADOR RAMPA LARGUERO EXTREMO...
  • Page 9 All manuals and user guides at all-guides.com Item: 1040200 RAMPA DE CARGA Description: Lea atentamente todas las instrucciones antes de armar, instalar y/o usar este producto. AMARRE EL EQUIPO A LA CANASTA DE CARGA BRAZO PASADOR PASADOR DE BLOQUEO GANCHO DE RESORTE MANIJA FIGURA 2 ADVERTENCIA: NO COLOQUE NINGUNA PARTE DEL CUERPO ENTRE LAS SECCIONES DE LA RAMPA CUANDO ABRA...

Ce manuel est également adapté pour:

Pro 1040200