Toro Power Max e26 Manuel De L'utilisateur page 25

3. Ensure that the scraper is 3 mm (1/8 inch) above
and parallel to a level surface.
Note:
If the pavement is cracked, rough, or
uneven, adjust the skids to raise the scraper. For
gravel surfaces, adjust the skids further down to
prevent the machine from picking up rocks.
4. Move the skids down until they are even with
the ground.
5. Firmly tighten the nuts that secure both skids
to the auger sides.
Note:
To quickly adjust the skids if they loosen,
support the scraper 3 mm (1/8 inch) off the
pavement, then adjust the skids down to the
pavement.
Note:
If the skids become excessively worn,
you can turn them over and set the unused side
toward the pavement.
Checking and Adjusting the
Traction Cable
Service Interval: After the first 2 hours—Inspect
the traction cable and adjust it if
necessary.
Yearly—Inspect the traction cable and adjust or
replace it if necessary.
If the machine does not drive in the forward or reverse
speeds or it drives when you release the traction lever,
adjust the traction cable.
If the left (traction) cable is not properly adjusted, do
the following steps:
1. Loosen the jam nut.
2. Engage the traction lever and hold it in place
(Figure 28).
3. Loosen or tighten the turnbuckle to adjust the
spring length to 5.5 cm (2–3/16 inches) as
shown in Figure
Figure 28
29.
1. Jam nut
2. Turnbuckle
4. Tighten the jam nut
there is slight tension on the cable.
5. If the traction cable is properly adjusted but a
problem remains, contact an Authorized Service
Dealer.
g001011
23
Figure 29
3. Spring
4. 5.5 cm (2–3/16 inches)
(Figure 29), ensuring that
g030998