Toro Power Max e26 Manuel De L'utilisateur page 21

Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute
and chute deflector into position
Figure 23
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the
left; move the Quick Stick to the right to move the
discharge chute to the right
Figure 24
•
If the chute does not move, refer to
Discharge-Chute Latch (page
•
If the chute does not turn as far to the left as it
does to the right, ensure that the cable is routed to
the inside of the handles. Refer to
Upper Handle (page
•
If the chute does not lock into place when you
release the trigger cap, refer to
Discharge-Chute Latch (page
(Figure 23).
(Figure 24).
Adjusting the
25).
2 Installing the
8).
Adjusting the
25).
Moving the Chute Deflector
Hold the blue trigger cap down and move the Quick
Stick forward to lower the chute deflector; move it
rearward to raise the chute deflector
g001014
Clearing a Clogged
Discharge Chute
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
•
To unclog the discharge chute, stay in the
operating position and release the left (traction)
lever. While running the auger/impeller, push down
on the handles to raise the front of the machine a
few centimeters (inches) off the pavement. Then
lift the handles quickly to bump the front of the
machine on the pavement. Repeat if necessary
until a stream of snow comes out the discharge
chute.
g018894
•
If you cannot unclog the discharge chute by
bumping the front of the machine, shut off the
machine, wait for all moving parts to stop, and
use the snow-cleanout tool
Important:
by bumping the front of the machine on the
pavement may cause the skids to move. Adjust
the skids and tighten the skid bolts securely;
refer to Checking and Adjusting the Skids and
Scraper (page
19
(Figure
Figure 25
(Figure
Unclogging the discharge chute
22).
25).
g001016
13).