GiBiDi BE24 Instructions Pour L'installation page 21

BE24
12 - DIP SWITCH DIP3
In order to store the new settings It's necessary to power down and power up the control board.
The default settings are highlighted in the boxes with grey background.
DIP Function
START COMMAND
3_1
ALLOCATION TO
3_2
TRANSMITTER
BUTTON
PEDESTRIAN
COMMAND
ALLOCATION TO
TRANSMITTER
3_3
BUTTON
3_4
If this setting is the same as
D I P 3 _ 1 a n d D I P 3 _ 2 ,
PEDESTRIAN is disabled.
3_5
UNUSED
3_6
UNUSED
13 - ONBOARD RADIO RECEIVER CONTROL
Storing a new transmitter in memory:
1 - Press and release Learn button.
2 - Led L6 will come on.
3 - Press button 1 of the transmitter to be stored for 2 seconds.
4 - The new transmitter is stored.
5 - Led L6 will stay on for another 5 seconds; during this period, you can store other transmitters, restarting from
step 3.
It ispossible to store up to 200 transmitters.
Clearing the memory:
1 - Press and hold down Learn button for 12 seconds.
2 - Led L6 will initially come on and then go off after 12 seconds.
3 - All the transmitters have now been deleted.
Assigning START and PED commands to the transmitter buttons:
Refer to Figure 17-18 and DIP3 configuration.
Status
OFF
Transmitter button 1.
OFF
OFF
Transmitter button 2.
ON
ON
Transmitter button 3.
OFF
ON
Transmitter button 4.
ON
OFF
Transmitter button 1.
OFF
OFF
Transmitter button 2.
ON
ON
Transmitter button 3.
OFF
ON
Transmitter button 4.
ON
OFF Keep this OFF, do not change.
ON
OFF
Description
21
UK