Assembly - Husqvarna HA110 Manuel D'utilisation

inspection. If you have a gasoline operated product,
disconnect the spark plug cap from the spark plug. If
you have a battery operated product, remove the
battery.
• Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
To assemble the hand guard and loop
handle - only gasoline products
(HA110)
WARNING: Never use HA110 with a battery
operated power unit.
1. Loosen the clutch sleeve's two mounting bolts and
dismantle the clutch sleeve.
2. Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts.
3. Slide the loop handle and hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
8
• Store the product out of reach of children.
• Use only original spare parts for repairs.

Assembly

5. Fit the nut and screw. Do not overtighten.
6. Now make a final adjustment to give yourself a
comfortable working position. Tighten the screw.
7. Fit the clutch sleeve and tighten the two mounting
bolts.
CAUTION: The loop handle and hand
guard must not be fitted behind the
arrow marked on the shaft.
820 - 003 - 07.02.2020