Troubleshooting - Husqvarna 325L Manuel D'utilisation

Masquer les pouces Voir aussi pour 325L:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Put the air filter oil in the plastic bag.
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove the
air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
To add grease to the bevel gear
Make sure that the bevel gear is filled 3/4 full with bevel
gear grease.
The engine does not start
Check
Stop switch.
Starter pawls.
Fuel tank.
882 - 001 - 10.10.2018

Troubleshooting

Possible cause
The stop switch is in the stop position.
The starter pawls cannot move freely.
Incorrect fuel type.
Procedure
Set the stop switch to the start position.
Remove the starter cover and clean around
the starter pawls.
Let an approved service agent help you.
Drain the fuel tank and fill with correct fuel.
17

Publicité

Table des Matières
loading

Table des Matières