Maintenance; Maintenance Schedule - Husqvarna 325L Manuel D'utilisation

Masquer les pouces Voir aussi pour 325L:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Introduction
WARNING: Before you do maintenance,
you must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance schedule

Weekly maintenance
Clean the external surfaces.
Make sure that the cutting attachment does not
move when on idle speed. Refer to
speed on page 15 .
Examine the level of grease in the bevel gear. Refer
To add grease to the bevel gear on page 17 .
to
Monthly maintenance
Make sure that the starter rope handle and the
starter rope is not damaged.
Yearly maintenance
Examine the spark plug. Refer to
spark plug on page 16
Clean the external surfaces of the carburetor and its
adjacent areas.
Clean the cooling system.
Examine the spark arrester screen. Refer to
maintenance on the spark arrester screen on page
15 .
Examine the fuel filter.
Make sure that the fuel hose is not damaged.
Make sure that cables and connections on the
product is not damaged.
To adjust the idle speed
Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
Adjust the idle speed with the idle adjustment screw
T which is identified with "T" mark.
The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be
below the speed when the cutting attachment starts
to turn.
882 - 001 - 10.10.2018

Maintenance

To adjust the idle
To examine the
To do
1. Turn the idle adjustment screw clockwise until the
cutting attachment starts to turn.
2. Turn the idle adjustment screw counterclockwise
until the cutting attachment stops.
To do maintenance on the spark
arrester screen
Use a wire brush to clean the spark arrester screen.
To clean the cooling system
Clean the parts of the cooling system with a brush.
1
2
15

Publicité

Table des Matières
loading

Table des Matières