Technical Data - EINHELL TS 125/115 Mode D'emploi

Anleitung TS 125 SPK1 23.06.2004
GB
cutting-off wheel has been fitted. Allow the
machine to run for approximately one minute
before you begin with the cutting. If the cutting-off
wheel has an invisible fracture or defect, it will
burst in less than one minute.
34.Keep your electric tools in a safe place. When
equipment is not being used it should be kept in a
dry, closed place out of children's reach.
35.Wear suitable work clothes. Do not wear loose
clothing or jewelry as they may get caught in
moving parts. Non-slip shoes are recommended.
Wear a hair net if you have long hair.
36.Always remove keys and wrenches after use.
Before switching on, make sure that all keys and
wrenches have been removed from the tool.
3. Assembly
See Fig. 2 to 10
4. Starting up
After you have switched on, lower the cutting-off
wheel slowly until it comes into contact with the
workpiece. Then carry out a smooth cut. Avoid
causing the cutting-off wheel to jump or chatter. This
will only lead to premature wear and result in poor
cuts or a broken cutting-off wheel.
5. Maintenance
Always keep the cutting stand clean.
Never use caustic agents to clean plastic parts.

6. Technical data

Applies for 115 mm and 125 mm angle grinder
Weight: 2.7kg
10
9:05 Uhr Seite 10