Using The Video And Audio Input Jacks - Sharp CR13M10 Mode D'emploi

Using the Video and Audio Input Jacks

L Connecting video equipment for playback of video material.
• When the television is connected to video equipment as shown below, the material being played
back on the video equipment can be seen on the television screen.
Connecting video device equipped with video output terminals.
CONNECTIONS
VIDEO EQUIPMENT
CAMCORDER
TV GAME
VCR
REV FWD
DVD
L To watch video material playback.
• Press the Remote's INPUT button to select the VIDEO INPUT mode for the video equipment you
wish to play.
• The external VIDEO INPUT mode will change as follows each time the INPUT button is pressed.
AIR INPUT
or (Front)
CABLE
• INPUT mode can be selected by pressing either the CH UP ( 8 ) on the TV remote control when the
TV is set to the highest channel stored in memory, or by pressing the CH DOWN ( 9 ) when it is set to
the lowest channel.
Note:
• When connecting video or audio equipment to the television, be sure that the power is turned off in
order to prevent damage to either the television or the equipment being connected.
• It is the intent of SHARP that this product be used in full compliance with the copyright law and that
prior permission be obtained from copyright owners whenever necessary.
• For detailed information on the connection and use of auxiliary equipment, refer to the instruction
manuals of the equipment being used.
• The connection cords can be obtained from your local video store.
16
14-16 CR13M10 [E].p65e
To VIDEO OUTPUT
To AUDIO OUTPUT
16
(Front connection
terminals of TV)
VIDEO IN AUDIO
8/5/01, 9:57 AM