Publicité
Les langues disponibles
Les langues disponibles
EnGLIsH
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
TROUBLESHOOTING
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local D
WALT repair agent.
e
WARNING: Before proceeding, release the bail bar to turn
mower off and wait for the blade to stop.
Problem
Possible solution
Mower doesn't run
Check to make sure mower battery is properly
when bail handle
installed and that the button on switch box is
is activated
being completely depressed before pulling the
bail handle.
Release bail handle to turn mower off. Remove
safety key and battery pack, turn mower over and
check that blade is free to turn.
Check that the battery cavity is free of debris and is
connected properly.
Has battery been fully charged? Press state of
charge button.
Motor stops
Release bail handle to turn mower off. Remove
while mowing
safety key and battery pack Turn mower over and
check that blade is free to turn.
Raise cutting height of wheels to highest position
and start mower.
Check that the battery cavity is free of debris and is
connected properly
Has battery been fully charged? Press state of
charge button
Avoid overloading the mower. Slow down the
cutting pace, or raise the cut height.
Mower runs but
Release bail handle to turn mower off. Uninstall
cutting performance
power source. Turn mower over and check:
is unsatisfactory
• Blade for sharpness - Keep blade sharp.
• Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for
grass condition. Raise cutting height.
Mower is too hard
Release bail handle to turn mower off. Uninstall
to push
power source. Raise cutting height to reduce deck
drag on grass. Check each wheel for free rotation.
42
Problem
Possible solution
Mower is abnormally
Release bail handle to turn mower off. Uninstall
noisy and vibrates
power source. Turn mower on side and check
blade to ensure it has not been bent or damaged.
If blade is damaged, replace with a D
replacement blade. If the underside of the deck is
damaged, return mower to a D
service centre.
If there is no visible damage to the blade and the
mower still vibrates:
• Release bail handle to turn mower off.
• Unplug mower.
• Disassemble entire blade assembly as described
in the Removing and installing
blade section.
• Remove any debris and clean each piece.
• Replace each piece as described in
the Removing and installing
blade section.
If mower still vibrates, return the mower to an
authorised D
Battery charger LEDs
Check plug connection.
not on
Replace charger.
Mower not picking up
Chute clogged. Release bail handle to turn
clippings with bag
mower off. Uninstall power source. Clear chute of
grass clippings.
Raise cutting height of wheels to shorten length
of the cut.
Bag full. Empty bag more often.
WALT
e
WALT Authorised
e
WALT service center.
e
Publicité
