Télécharger Imprimer la page

DeWalt DCMW564 Traduction De La Notice D'instructions Originale page 42

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 59
EnGLIsH
remove batteries before lifting, transporting, or storing the
mower. Store in a dry place.

CAUTION: Pinch point. To avoid being pinched, keep
fingers away from area around handle brackets when
folding down handles.

CAUTION: Make sure cord does not become stretched
or pinched in the area between the handle and handle
bracket during folding. This can cause damage to the cord.
The handle of the mower can be easily folded down for quick
and convenient storage.
1. To unlock the handle 
 4 
, pull and twist a half turn the two
handle locks 
located on both sides of the handle.
 6 
2. Fold the handle to the front of the mower as shown in
Fig. M.
3. Locate the handle storage detent holes 
handle brackets 
as shown in Fig. M.
 7 
4. Lock the handle in place by untwisting the handle locks 
allowing them to snap into the storage detent holes and
ensure the handle is firmly latched as shown in Fig. M.
Carrying the Mower (Fig. A, N)

DANGER: Rotating blades can cause serious injury.
To prevent serious injury, remove safety key and
battery packs when unattended, or when charging,
cleaning, servicing, transporting, lifting, or
storing mower.
The mower can be carried using the convenient carry
handles
 14 
,
 15 
as shown in Fig. N. DO NOT attempt to lift
the mower by grasping the main handle
Mowing Tips

WARNING: ALWAYS INSPECT AREA WHERE MOWER
IS TO BE USED AND REMOVE ALL STONES, STICKS,
WIRE, BONES, AND OTHER DEBRIS WHICH MIGHT BE
THROWN BY THE ROTATING BLADE.

WARNING: Mow across the face of slopes, never up-and-
down. Exercise extreme caution when changing direction
on slopes. Do not mow excessively steep slopes. Always
maintain good footing.
1. Release bail handle to turn mower "OFF" when crossing any
gravel area (stones can be thrown by the blade).
2. Set mower at highest cutting height when mowing in
rough ground or in tall weeds. Removing too much grass at
one time can cause the motor to be overloaded and to stop.
Refer to Troubleshooting Section.
3. If a grass collection bag 
 12 
season, the grass may tend to clog up at the discharge
opening. Release bail handle to turn mower off, remove
the safety key and battery packs. Remove the catcher and
shake the grass down to the back end of the bag. Also clean
out any grass or debris which may be packed around the
discharge opening. Replace the grass catcher.
4. If mower should start to vibrate abnormally, release bail
handle to turn mower off, remove the safety key and battery
packs. Check immediately for cause. Vibration is a warning
of trouble. Do not operate mower until a service check
40
 8 
located on the
 6 
 4 
.
is used during the fast growing
has been made. Refer to troubleshooting section in this
manual.
5. For best cutting results, keep blade sharpened
and balanced.
6. Inspect and thoroughly clean mower after each use as a
deck with caked grass will degrade performance.
7. aLWaYs RELEasE BaIL HanDLE TO TURn MOWER
OFF, REMOVE saFETY kEY anD BaTTERY Packs WHEn
LEaVInG IT UnaTTEnDED EVEn FOR a sHORT PERIOD
OF TIME.
The following suggestions will help you
to obtain optimum run time from your
cordless mower:
Slow down in areas where the grass is especially long
or thick.
Avoid mowing when the grass is wet from rain or
dew soaked.
Cut your lawn frequently, especially during high
growth periods.
nOTE: It is recommended that your mower be recharged
after use to prolong the battery life. Frequent charging
will not harm your battery, and will ensure that the
battery is fully charged and ready for its next use. storing
battery not fully charged will shorten battery life.
MAINTENANCE

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and remove
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
Removing and Installing Blade (Fig. O – Q)

DANGER: RISK OF INJURY. WHEN REASSEMBLING THE
BLADE SYSTEM, ENSURE EACH PART IS REINSTALLED
CORRECTLY, AS DESCRIBED BELOW. IMPROPER ASSEMBLY
OF THE BLADE OR OTHER PARTS OF THE BLADE SYSTEM
MAY CAUSE SERIOUS INJURY.

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and remove
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
1. Cut a piece of 2x4 wood 
 24 
blade from turning when removing the flange nut  

WARNING: Use gloves and proper eye protection. Turn the
mower on its side. Be careful of sharp edges of blade.
2. Position wood and unscrew flange nut  
counterclockwise with a 18 mm wrench 
Fig. O.
3. Remove square metal blade spacer  
blade insulator  
 28 
and blade  
blade fan 
 30 
should not be removed. Examine all pieces for
damage and replace if necessary.
(about 610 mm long) to keep
 25 
.
 25 
 26 
as shown in
, square plastic
 27 
 29 
as shown in Fig. P. The

Publicité

loading