ASROCK K7Upgrade-600 Mode D'emploi page 8

Les langues disponibles

2.2 Installation of Memory Modules (DIMM)

K7Upgrade-600 motherboard provides two 184-pin DDR (Double Data Rate) DIMM

slots.

Installing a DIMM

Please make sure to disconnect power supply before adding or

removing DIMMs or the system components.

STEP 1:

Unlock a DIMM slot by pressing the retaining clips outward.

STEP 2:

Align a DIMM on the slot such that the notch on the DIMM matches the

break on the slot.

The DIMM only fits in one correct orientation. It will cause permanent

damage to the motherboard and the DIMM if you force the DIMM into the

slot at incorrect orientation.

STEP 3:

Firmly insert the DIMM into the slot until the retaining clips at both ends

fully snap back in place and the DIMM is properly seated.

8 8 8 8 8

ASRock K7Upgrade-600 Motherboard