ASROCK K7Upgrade-600 Mode D'emploi page 14

Serial ATA (SATA)
Power Cable
(Optional)
HDD power connector
USB 2.0 Header
(9-pin USB67)
(see p.2, No. 22)
USB 2.0 Header
(9-pin USB45)
(see p.2, No. 23)
Infrared Module Header
(5-pin IR1)
(see p.2, No. 25)
Internal Audio Connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.2, No. 34)
(AUX1: see p.2, No. 35)
Front Panel Audio Header
(9-pin AUDIO1)
(see p.2, No. 26)
1 4 1 4 1 4 1 4 1 4
connect to the SATA
connect to the
power supply
AUX1 CD1
ASRock K7Upgrade-600 Motherboard
Please connect the black end of
SATA power cable to the power
connector on the drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
ASRock I/O provides you
4 ready-to-use USB 2.0 ports on
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 4 extra USB 2.0 ports.
ASRock I/O provides you
4 ready-to-use USB 2.0 ports on
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 4 extra USB 2.0 ports
This header supports an optional
wireless transmitting and
receiving infrared module.
These connectors allow you
to receive stereo audio input
from sound sources such as
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
This is an interface for the front
panel audio cable that allows
convenient connection and
control of audio devices.