habitat et jardin USAIN Mode D'emploi page 19

Fault Code
E01 The wire from computer to bottom
control board didn't connected well
E02 Protect the exploding
E05 Over current Protection
E06
19
TROUBLE SHOOTING
Main reason
Motor wire is not connect well
Solution
1 ． Check the connection wire between
computer and control board was well
connected.
2 ． Make sure the IC on the control board
was well inserted. If not re-insert.
3． Abnormal power supply in control board.
Please change a new control board.
1 ． Bad contact with motor open circuit.
Please change a new motor or check the
connector.
2． Power tube was puncture. Please change
a new Power tube or control board.
1． Overloaded。
2 ． Running board with heavy resistance.
Need to be oiled
3． Damage in Motor. Change a new motor.
1. Check the motor wire and Circuit control
board wire connect well
2. Check if the control board have peculiar
smell,change the control board