Care And Cleaning; Sink; Cabinet - Conglom QL029K Manuel De L'utilisateur

Care and Cleaning

Your utility cabinet is manufactured with the highest grade materials and will provide you many years of enjoyment with the proper care .

SINK

Do
- After use, always rinse your sink with tap water to dilute and
remove deposits .
- Towel dry after use whenever possible to prevent water spots .
Should water spots occur, clean with a mild solution of vinegar
and water followed by a thorough rinse .
- Use liquid soap, a general household cleaner, or a weak solution
of vinegar and water for regular cleaning .
- Only use plastic scouring pads recommended for use in
stainless steel sinks, and only use them in the bowl of the sink .
Scrub in the direction of the satin finish lines.
Do not
- Do not allow any food, detergent, soap or grease to dry or sit for
extended periods of time on the surface of the sink.
- Never use abrasive cleaning products, as they will dull and
scratch the finish.
- Do not use scouring pads on the deck, as they will dull the
finish.
- Never use steel wool pads or leave steel/cast iron pans in
your sink for extended periods of time, as they will leave iron
particles on the sink, which can cause corrosion .
- Never use chlorine-based cleaners in your new sink, they could
lead to rust spots and discolouration . If you must use them,
rinse sink thoroughly with fresh water immediately after use .
- If any chemicals or glue make contact with the sink during
installation, wipe clean and rinse thoroughly with fresh water .
SCRATCH, SPOT, AND BLEMISH REMOVAL AND SURFACE RESTORATION:
Little rust spots and blemishes that periodically appear in the sink are typically the result of the steel interacting with the chemicals
found in the vast spectrum of substances that sinks are commonly exposed to. They may also get transferred from other objects
placed or left in the sink . Scratches are the result of regular wear and tear .
To remove scratches, spots, and blemishes from the sink, rub them with a non-metallic scouring pad (e.g. Scotch-Brite
with a mild abrasive cleaner (e.g. Barkeeper's Friend
finished, rinse the sink with water and dry it with a towel to allow the sink to form a protective outer layer. This procedure can also be
used to renew all of the surfaces of the sink .
QL029K

CABINET

Do
- Remove dust and dry dirt with a soft, damp cloth .
- Clean grease, oil, paint and ink stains with isopropyl
(rubbing alcohol). Immediately rinse with water after stain
removal .
Do not
- Do not allow your cabinet surface to come into contact
with products such as acetone (nail polish remover), nail
polish, dry cleaning solution, lacquer thinners, gasoline,
pine oil, etc .
- Use caution when using sharp instruments that may fall
and scratch the surface .
). Always rub the surfaces in the direction of the grain of the steel. When
®
14
) combined
®