Faucet Installation - Conglom QL029K Manuel De L'utilisateur

Installation (continued)

FAUCET INSTALLATION

- Connect the sprayer head (1) to the sprayer head
connector (2).
- Remove the gasket (3), metal washer (4), and retaining
nut (5) from the faucet.
- Install the faucet through the hole in the sink .
- From underneath, secure the faucet to the sink with the
gasket (3), metal washer (4), and retaining nut (5).
- Tighten the retaining nut (5) by hand until it is snug.
Use a wrench to tighten it down . Gently tighten the two
screws on the retaining nut . Do not overtighten .
- Hand-tighten the hose (6) to the faucet outlet (7).
Tighten the fittings using two wrenches. Hold the faucet
outlet (7) steady with a wrench while turning the hose
fitting with another wrench until it is snug.
NOTE: Failing to use two wrenches can damage the
faucet. Do not overtighten.
- Push the sprayer head (1) into the faucet neck. Install
the counterweight (8) a couple of inches from the
bottom of the hose on the side closest to the sprayer
head (1). There should be no slack in the hose and it
should retract freely .
- Connect the water supply lines (not supplied) to the
faucet .
- This faucet is equipped with standard 1/2" NPS male
thread connectors that are compatible with standard
1/2" FIP water supply lines .
QL029K
Faucet body
Gasket (3)
Retaining nut (5)
Water connectors (9)
Counterweight (8)
Faucet outlet (7)
Hose (6)
10
Sprayer head
connector (2)
Sprayer head (1)
Sink
Metal washer (4)
Screws
Faucet outlet (7)
Hose (6)
Water connectors (9)
1/2" NPS thread
1/2" FIP water supply
line compatible
(not supplied)
Fig . 9