Strainer Installation - Conglom QL029K Manuel De L'utilisateur

Installation (continued)

STRAINER INSTALLATION

- Apply plumbing putty or silicone sealant to the top side
of the drain opening .
- Insert the strainer body (1) into the drain opening and
press it down until it is evenly seated .
- Assemble the rubber gasket (2), fiber washer (3) and
strainer locknut (4) onto the strainer body (1) from
underneath the sink . Hand tighten the strainer locknut
(4) until it is snug. Do not overtighten.
- Insert the plastic flange (5) into the flange-end of the
tailpipe (6) (not supplied) then secure the tailpipe to the
strainer body using the connecting nut (7). Tighten the
connecting nut (7) until it is snug. Do not overtighten.
- Remove excess sealant from around the drain opening.
Sink
Fig . 10
11
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Strainer Basket
Strainer Body (1)
Sealant
Rubber Gasket (2)
Fiber Washer (3)
Strainer Locknut (4)
Plastic Flange (5)
Tailpipe (6)
(not supplied)
Connecting Nut (7)
CONGLOMKB .COM