Drain Hose Connection - Bosch Integra 500 Série Instructions D'installation

Silver
Spring
Clamp
Gold
Screw
Clamp
Figure 23
Figure 25

Drain Hose Connection

Installation of the Rubber Drain Hose
Adaptor
1 Obtain the Rubber Drain Hose Adaptor and the two
2 On one outside end of the Rubber Drain Hose Adapter
3 Secure the connection with the Silver Spring Clamp.
4 Use the Gold Screw Clamp to attach the Rubber Drain
Connecting the Drain Hose to the
Household Plumbing
The dishwasher drain hose may be connected to the drain
plumbing in one of four ways:
1 Directly to the under-sink dishwasher drain connection,
2 Directly to a disposer dishwasher drain connection, as
3 To the under-sink dishwasher drain connection through
4 To a disposer dishwasher drain connection through an
Information on installing air gaps and disposers can be
found in the Plumbing Preparation section of this
manual.
Figure 24
NOTE: If the dishwasher drain hose is to be connected to
a disposer dishwasher drain connection, remove the plug
from the disposer's dishwasher drain connection.
Use the supplied Rubber Drain Hose Adaptor and Drain
Hose Clamps to connect the dishwasher drain hose to the
plumbing drain connection. Use the spring clamp to
secure the Rubber Drain Hose Adaptor to the dishwasher
drain hose. Use the screw clamp to secure the Rubber
Drain Hose Adaptor to the plumbing drain connection.
The dishwasher drain hose must have one place along its
length that is securely attached 20 inches above the
cabinet floor.
Figure 26
hose clamps from the Dishwasher Installation Kit.
is a raised groove. Insert the drain hose into the end
without the raised groove. Be sure to fully insert the
drain hose.
Hose Adaptor to the house plumbing.
as shown in Figure 23.
shown in Figure 24.
an air gap, as shown in Figure 25.
air gap, as shown on Figure 26.
11