Securing The Dishwasher; Drain Hose Connection - Bosch SHU43C06UC/43 Mode D'emploi

Figure 20
a
b
Top Mount
Figure 21
Figure 22
Leg
Leveler
Locking
Screw
Rubber Drain Hose Adaptor
(cross section)
Raised Rib
Connects to house-
hold plumbing
Figure 23
Placing the Dishwasher/ Securing the Dishwasher
Side Mount
Screw
Boss
Dishwasher
Drain Hose
Insert until drain
hose locks in place

SECURING THE DISHWASHER

1 Drive the mounting screws through the holes in the
mounting brackets as shown in Figure 21 for Top or
Side Mount.
2 After the unit is installed in the enclosure, leveled and
secured, lock the two front leg levelers in place by
driving the enclosed leg leveler locking screws into
each screw boss located in front of the levelers. See
Figure 22.
3 Tighten screws until they are flush with the surface of
the bosses.
Installation of the Rubber Drain Hose
Adaptor
1 Obtain the Rubber Drain Hose Adaptor and the two
hose clamps from the Dishwasher Installation Kit (do
not substitute).
2 On one outside end of the Rubber Drain Hose
Adapter is a raised rib. Insert the dishwasher drain
hose into the end without the raised rib (see Figure
23). Be sure to fully insert the drain hose.
3 Secure the connection with the Spring Clamp (see
Figure 24).
4 Use the Screw Clamp to attach the Rubber Drain
Hose Adaptor to the house plumbing (see Figure 24).
Raised
Rib on
Outside
of Drain
Hose
Adaptor
Spring
Clamp
Screw
Clamp
Figure 24
11