Base And Toe Panel; Final Instructions - Bosch SHU43C06UC/43 Mode D'emploi

c
d
Figure 36
Base and Toe Panel/ Final Instructions
BASE AND TOE PANEL (Continued)
Method B - Plastic Base Access Panel and Toe Panel
Installation (select models)
1 Place the Plastic Base Access Panel under and up
the front bottom panel of the dishwasher, as shown in
Figure 36a.
a
2 Insert the Plastic Base Access Panel screws into the
Plastic Base Access Panel, as shown in Figure 36b.
Tighten the Plastic Base Access Panel Screws.
b
3 Place the Cotton Insulation Strip under the unit,
between the bottom of the Plastic Base Access Panel
and the floor, as shown in Figure 36c.
4 Attach the Metal Toe Panel to the Plastic Base
Access Panel using the Toe Panel Screws included in
the Toe Panel Installation Kit. See Figure 36d.
NOTE: You will not use the normal Toe Panel Screws
included in the Dishwasher Installation Kit on these
models.
In some conditions, Hydrogen gas can form in
a hot water system that has not been used for
weeks. Hydrogen gas is explosive. Before filling
a dishwasher from a system that has been off
for weeks, run the water from a nearby faucet in
a well ventilated area until there is no sound or
evidence of gas.

FINAL INSTRUCTIONS

1 Energize the dishwasher power supply circuit.
2 Consult the Dishwasher Use and Care Manual, and
run the dishwasher through one complete cycle. If
the dishwasher does not operate properly, refer to
the Self-Help section of the Use and Care Manual. If
the dishwasher still does not operate properly, refer
to the Customer Service Section of the Use and Care
Manual.
WARNING
15