Attaching The Toe Panel - Bosch SPX68U55UC Notice D'installation

Attaching the Toe Panel

Your dishwasher comes with either a two-piece or three-
piece toe panel (model dependent) to allow height adjust-
ment.
of the rear toe panel allowing the angled edge to rest
on the mating edge of the dishwasher.
3. Drive the two black screws (A) through the holes in the
toe panel to secure. Use the supplied screws to avoid
damaging the dishwasher. See Figure 24.
4. For models with a three-piece toe panel, the rubber
apron removed earlier may now be attached and should
remain behind the outermost toe panel.
5. For models with outer toe panel (3rd piece - N) slide
you just attached.
6. Once you determine the correct position for the brack-
ets, remove the bracket and bend the metal tab. See
Figure 25. This ensures that the toe panel will not slide
in further than you need.
7. Re-insert the brackets.
8. Attach the outer toe panel (N) onto the brackets and drive
the screws provided (O) in place to secure the toe panel
ensuring that the rubber apron is completely hidden
behind the outer toe panel.
12
Figure 24
A
N
O
Figure 25
D
A
12