LAS PREMIUM Manuel page 13

Finally, place the safety belt around the bicycle frame and the U-bracket and pull tight.
(see sketch)
The keys for the frame holders should be kept safely.
Caution: Never use the rack without the safety belt!
2 lashing straps on the front wheel
1 lashing strap on the rear wheel
Caution: for fastening the license plate, you will need to press out 2 molded parts from the
license plate bracket beforehand, 2 remain as spare. See photo. These molded parts are
pressed into the 2 recesses provided for this purpose after having inserted the license
plate. See photo.
Set the rotatable fastener into the opening position and pull up the lever. Doing this,
keep hold of the U-bracket to prevent the rack from suddenly folding downwards. With
the other hand, pull the lever of the folding mechanism upwards. You may now carefully
fold down the rack. Lifting the rack table will snap it in into the end position. Caution:
Following this, the safety lever needs to be locked again using the rotatable fastener.
Safety belt
Recess
Folding down the bicycle rack
13
License plate
Molded part
18
Recess