Kohler K-1652 Guide D'installation page 6

Determine the Location of the Steam Hardware (cont.)
Identify the model number of the shower module as shown in the illustration.
Determine the location of the steam head and steam control for the module as shown in the
modules illustration.
Ensure clearance between the steam line and any surrounding surfaces.
Refer to the Steam Control Kit Installation Instructions for more information.
For Custom Shower Applications
WARNING: Risk of personal injury. Do not install the Steam Control User Interface outside the
steam enclosure. The User Interface must be installed within the enclosure to allow the sensors to
regulate the temperature and control the flow of steam. Refer to the Installation Guide for the
Steam Control Kit.
NOTE: All dimensions should be taken from the inside of the shower.
IMPORTANT! Do not install the steam control directly above or in-line with the steam head.
It is recommended to locate the steam head and the steam control on the same wall as the plumbing
controls.
Locate the steam head 6" (15.2 cm) above the shower floor and 4 1/2" (11.4 cm) from the threshold.
Locate the steam control 60" (152.4 cm) above the floor of the shower. Refer to the Steam Control Kit
Installation Instructions for more dimensional and installation information.
Make sure there is adequate clearance between the steam line and any surrounding surfaces.
1060226-2-G 6 Kohler Co.