Kemper Dusty Evo Notice D'utilisation page 74

7.3 Troubleshooting
Fault
Product will not
start up
Not all fumes are
being captured
Extraction
capacity too
low/non-existent
Dust escapes on
the clean air side
Signal lamp for
filter saturation
lights up
NOTE
If the fault cannot be corrected by the customer, please contact the
manufacturer's service department.
7.4 Emergency measures
In case of fire of the product or its detection elements, the following steps
should be taken if necessary:
1. Where possible, disconnect the product from the power supply by
unplugging.
2. If present, disconnect the compressed air supply.
3. Fight fire with a commercially available dry powder extinguisher.
4. Notify local fire brigade if necessary.
1502937-00
Cause
No mains voltage
Start/stop sensor (optional
fitting) connected but no
welding current detected.
Welding process not yet
started
Draught
Incorrect extraction
capacity set
Filter inserts saturated
Welding burner clogged
Filter inserts damaged
Filter cartridge saturated
Tab. 21: Troubleshooting
- 74 -
Note
Have it checked by a
qualified electrician
Start welding process
Avoid draughts
Check and correct
required extraction
capacity
Replace filter inserts
Clean the welding burner
Replace filter inserts
Cleaning of the filter
cartridge required, see
"Maintenance" chapter
EN