VONROC AG503AC Notice Originale page 9

ning wheel and the power tool directly at you.
c) When wheel is binding or when interrupting a
cut for any reason, switch off the power tool
and hold the power tool motionless until the
wheel comes to a complete stop. Never attempt
to remove the cut-off wheel from the cut while
the wheel is in motion otherwise kickback may
occur. Investigate and take corrective action to
eliminate the cause of wheel binding.
d) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re-enter the cut. The wheel may bind,
walk up or kickback if the power tool is restart-
ed in the workpiece.
e) Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kick-
back. Large workpieces tend to sag under their
own weight. Supports must be placed under the
workpiece near the line of cut and near the edge
of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket cut"
into existing walls or other blind areas. The
protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kick-
back.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard must
be used (not included). Fig. D2.
Not suitable for construction site usage.
WWW.VONROC.COM
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Grinding disc
Diameter:
Bore:
Spindle thread
Weight
Sound pressure level L
PA
Acoustic power level L
WA
Vibration
Main handle
Auxiliary handle
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardized test given in EN60745; it may be used
to compare one tool with another and as a prelim-
inary assessment of exposure to vibration when
using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Spindle lock button
2. Allen screw
3. Protection guard
4. Carbon brush cover
5. On/Off switch
EN
AG503AC
220-240V~
50Hz
2400W
6800 /min
230 mm
22.2 mm
M14
5.5 kg
97.6 dB(A), K=3dB(A)
108.6 dB(A), K=3dB(A)
11.598 m/s2, K=1.5 m/s2
5.618 m/s2, K=1.5 m/s2
9