Intended Use; Charging The Battery; Assembly; Operation - Batavia MAXX Serie Mode D'emploi

English

7. Intended use

• The rain barrel pump is designed for
pumping clear water only.
• The rain barrel pump is intended for
pumping water from a rainwater butt or
rainwater collecting tank. It is particu-
larly suitable for watering plants in the
garden.
• It is not intended for delivering salt
water, corrosive, easily flammable or
explosive liquids (e.g. petrol, paraffin,
thinners, etc.), faces, oil, heating oil or
foodstuffs.
• This pump is not intended for commer-
cial or industrial purposes.
• The pump is not suitable for continuous
operation, e.g. for watercourses in gar-
den ponds.
• The intended use also includes an oper-
ation following the operating instruc-
tions. Any use beyond these parameters
(different media, applying force) or any
changes (reconstruction, no original
accessory) can lead to serious risks and
is regarded as use that is contrary to
the intended purpose.

8. Charging the battery

(See Fig. B).
Before using the pump for the first time,
fully charge the battery.
Connect the battery charger (9) with a
8.1
wall socket. The LED lights up green to
indicate that power is on.
Connect the battery (11) with the bat-
8.2
tery charger. The LED lights up red to
indicate that the battery is charging.
Charge the battery for approx. 6 hours.
When the battery is fully charged, the
LED lights up green.
After charging process, disconnect the
8.3
charger from the unit and unplug from
mains.
10

9. Assembly

(See Fig. C).
Before each use, check the pump for
9.1
any damages. Do not use the pump in
case of damages.
Place the sealing washer (10) on the
9.2
pump housing (7) and screw the nut (6)
on the housing.
Tightly attach the hose (not included) to
9.3
be used for pumping off the water to
the quick connection of the shut-off
valve (1).
For extra length you can add the
9.4
optional extension tube (14).

10. Operation

(See Fig. D).
Set the rain barrel pump on a flat sur-
10.1
face into the water supply you want to
pump off. Make sure that the pump
cannot move during operation. Pay
attention to the maximum submersion
depth. Always make sure that the suc-
tion opening (8) is not blocked or
obstructed during operation. If neces-
sary, place the pump on a brick or
similar.
Run the irrigation hose for watering the
10.2
plants. Observe the maximum delivery
height.
Open the shut-off valve (1).
10.3
Insert the battery (11) into the battery
10.4
compartment (4). To switch on the rain
barrel pump, push the ON/OFF switch
(2) in direction I. To switch off the pump
push the switch (2) in direction O.
(See Fig. E).
When not in use, remove the battery
10.5
from the battery compartment. Depress
the release button on the battery and
pull out the battery from the
compartment.
• Make sure that water and moisture
cannot get into the control unit.
• Make sure that no particles bigger than
approx. 1 mm are sucked into the
pump.
• Never pull the rain barrel pump by the
cord.