What If There Are Problems - Beurer EM 25 Mode D'emploi

Output max. 90 mApp (1000 ohm)
current
Voltage 2 x 1.5 V AAA battery
supply
Treatment 20 minutes, the device then switches off
time automatically
Intensity Adjustable from 0 to 15
Operating 10°C – 40°C (50°F – 104°F) at a relative
conditions humidity of 30 – 85%
Storage con- -10°C – 50°C (14°F – 122°F) with a relative
ditions humidity of 10–95%
Dimensions 429 x 125 x 21 mm
Weight 110 g (without batteries),
133 g (with batteries)
note:
If the device is not used according to the instructions spe-
cified, perfect functionality cannot be guaranteed!
We reserve the right to make technical changes to impro-
ve and develop the product.

7. What if there are problems?

Problem
Device will not
switch on.
The gel film no
longer adheres to
the skin.
The device beeps
unusually during
use.
17
Possible cause/remedy
- Press and hold down the " " but-
ton again for 1.5 seconds.
- Check that the batteries are
inserted correctly and try to switch
on the device again.
- The batteries could be flat.
Replace the batteries and try to
switch on the device again.
- Replace the gel film.
- Press and hold down the " "
button for 1.5 seconds to switch
off the device. Then press and
hold down the " " button for 1.5
seconds to switch on the device
again.
- There is insufficient skin contact
with the gel pads. Replace the gel
pads.
- The batteries could be low and
must be replaced.