Titan TA 220 Mode D'emploi page 34

Charging the lithium – polymer storage battery
8.4.
Put the Li-Po storage
The charging operation
The charging operation
battery in the charger
has ended, when the
starts automatically, the
until it engages audibly.
LED status light
LED status indication is
becomes green.
bright (red).
Explanation of charging stages:
The LED status indication is either red or
green.
Red LED is bright - storage battery
is being charged, charge 0 to 80 %
Green LED is flashes - storage battery
is being charged, charge 80 to 99 %
Green LED is bright - storage battery
fully charged, charge 100 %
Red LED flashes - storage battery
overheated or voltage below 10.4 V
for troubleshooting required
see item 10 Remedy of faults
After the end of the charging operation remove the Li-Po storage battery from the charger
and also pull the mains connector of the charger out of the socket. This helps avoid
unnecessary expenses for power.
34 / 64
TA 220
H TA 220 EU 37/09