Titan TA 220 Mode D'emploi page 28

6. Operation
6.1. Commissioning
Never operate the TA 220 without plastic strap; tensioning roller, welding device and the
cutter could get damaged.
The operation of the TA 220 requires a sufficiently charged Li-Po storage battery;
when the tool was delivered you received a fully charged storage battery. Should the Li-Po
storage battery not be charged fully, charge it please (for this, see section 8 - Accessories).
To start operations of the TA 200 plug the
Li-Po storage battery into the slot provided
till the stop is reached.
To enable the tool please press pushbutton
1 for a moment, the LED signal lamp flashes;
the tool TA 220 is ready for operation.
LED signal lamp
Flashes Stand-by mode
Is bright Tool in operation
TA 220
H TA 220 EU 37/09
Pushbutton 1
28 / 64