Titan TA 220 Mode D'emploi page 30

To form a seal draw lever 2 towards you; friction
welding starts.
The LED is bright; an audible acoustic signal
indicates the end of the welding cycle after a few
seconds and the strap is cut automatically.
The seal is formed!
Pull lever 3 to the grip; the strap is released then,
hold it firmly. Then swing the tool to the right out
of the strapping.
Check your seal; it should look like
that.
If your seal is not similar to the one in the figure, the welding time may have been set
wrongly. Optimise the seal, see item 7 (settings).
Message state of charge lithium – polymer storage battery
6.1
With each acoustic signal which can be heard when the seal is formed the LED display
informs about the state of charge of the lithium – polymer storage battery.
Li-Po storage battery
Li-Po storage battery Li-Po storage battery
fully charged
almost empty almost empty!
(For charging see item 8.4)
30 / 64
TA 220
H TA 220 EU 37/09