Sanitas SFT 22 Mode D'emploi page 19

Always store the thermometer with the cap on in order to protect the sensor.
The device must not be stored or used at too high or low a temperature or humidity (see technical specifications), in sun-
light, in association with an electrical current or in dusty locations. Otherwise, inaccuracies can occur.
If prolonged storage is intended, you should remove the battery.
The device must be tested for accuracy (calibrated) after 2 years. Please send the complete device to the dealer's or
service address.
Please dispose of the device in accordance with the directive 2002/96/EG – WEEE (Waste Electrical and Electronic
Equipment). If you have any queries, please refer to the local authorities responsible for waste disposal.
9. Technical data
Note: When the device is used outside the specifications, perfect functioning cannot be guaranteed.
We reserve the right to make technical changes to improve and develop the product.
Model
Measurement range
Laboratory measurement
precision
Clinical repeat precision
Measurement duration
Interval between 2 measurements
Measurement units
Ambient operating conditions
Storage conditions
SFT 22
93.2 °F – 109.4 °F
±0.4 °F between 95.9 °F – 107.6 °F
±0.5 °F < 95.9 °F > 107.6 °F
0.56 °F (children, 1 to 5 years), 0.50 °F (adults)
1 to 2 seconds
At least 10 seconds
°Celsius (°C) or °Fahrenheit (°F)
60.8 °F – 95 °F with a relative humidity of up to 85 % (non-condensing)
-13 °F – 131 °F with a relative humidity of up to 85 % (noncondensing)
19