FLO-DYNAMICS CCST 388 Manuel D'utilisation page 12

Set the quantity of fluid to be added as follows:
1. Set the quantity of refrigerant in pounds for the A/C system to be charged. For
example, for 1lb 7 oz. press key 1, key 0 and key 7, "Filling 1:07lb". After setting the
quantity, confirm by pressing the ENTER key.
VACUUM 20 min
AUTOMATIC OIL
<FILLING
VACUUM
OIL
<FILLING
On most systems, the quantity of fluid to be charged is given on the plate inside the
engine compartment of the vehicle. If you do not know the correct quantity, consult the
relevant manuals.
2. The DATABASE BASIC may be used if installed. Press the ↓ key. The following will
appear on the display
Find the relevant vehicle code on the "table" provided. Use the numerical keypad to
enter the code. Then press the ENTER key to confirm. The following will appear on
the display:
where "w:yz" refers to the weight of refrigerant for the vehicle selected. The machine is
now ready to enter the correct quantity of refrigerant. Confirm by pressing the ENTER
key. Please contact your retailer if you wish to install the DATABASE BASIC (DBB).
3. The DATABASE ADVANCED (DBA) may be used if installed: Press the ↓ key, the
following will appear on the display
Use the arrow keys (↓↑) to select the required vehicle brand and press ENTER to confirm.
The display will now show the various models (for example, if the brand chosen was FORD): *
INSTRUCTIONS MANUAL
x:xx lb>
20 min
30 CC
x:xx lb
>
INSERT CODE
CAR MODEL
Press ENTER to quit
VACUUM
OIL
<FILLING
<ALFA ROMEO>
AUDI
BMW
CHRYSLER/JEEP
<COUGAR>
ESCORT
ESCORT D
FIESTA
8 5 0 ENTER
000
20 min
30 CC
w:yz lb
>
-12-
Open high and low
pressure, then
press START.