Installer Checklist; Troubleshooting Tips - Danby DDW18D1EW Manuel D'installation

INSTALLATION INSTRUCTIONS

INSTALLER CHECKLIST

Check the following:
• The dishwasher is square and level
• The dishwasher is fastened securely to the
cabinet
• The door opens and closes freely without hitting
the cabinetry or counter top
• The inlet water supply does not leak
• The drain hose is connected, there are no bends
or kinks in it and it does not leak
• The drain hose must be installed with a 28" (71
cm) high drain loop for drain hook ups without
any air removed
• The the drain hose is connected to a trap spigot
under the sink, remove the plastic membrane so
that remaining food does not cause a blockage
in the drain hose spigot and ensure a hose
clamp is used to secure the hose to the spigot
• The spray arms can rotate freely
• The rinse cycle has been run
• The water level will be below the fi lter screen
after the end of the wash program
• It is normal to fi nd some water in the drain fi lter
area
FINAL TEST
1. Press the on/off button to turn the dishwasher
on.
2. Power indicator light comes on.
3. Use the program select button to choose a
washing program.
4. Start the program with the start/pause/cancel
button.
5. Run the dishwasher through one complete cycle.
When the wash cycle is completed use the on/
off button to turn the dishwasher off.

TROUBLESHOOTING TIPS

The display screen does not turn on
• Check to make sure the breaker to the
dishwasher is turned on.
• Check to make sure the power cord is plugged
in.
No water is entering the dishwasher
• Check to make sure the water shut off is in the
on position.
Water does not drain from the dishwasher
• Make sure the drain hose is not kinked or comes
out of air gap next to the sink.
• Remove the drain hose from the disposal and
make sure the plug is removed.
9