Cleaning - Bartscher 1KA10 Mode D'emploi

The device is equipped with the thermostat protection unit that will be
activated in case of thermostat failure. The device shall switch off automatically.
Note: when the thermostat protection unit is activated, unplug the device
and let it cool down. Notify the maintenance service or contact the
supplier.

6. Cleaning

CAUTION!
Before cleaning, set the ON/OFF switch at "O"and disconnect the device
from the mains (unplug!).
Let the device cool down.
The device is not designed to be rinsed with running water.
Do not use a pressure washer to clean the device!
Be careful and do not let the water into the device.
Cleaning
o Clean the device regularly.
o Clean it with a soft cloth only and never use any abrasive cleaning agents that
could cause damage to the surfaces of the device or its accessories.
WARNING! Risk of scalding!
Let the water cool down before removing it or draining it through the drain tap.
Splashes of hot water may cause scalding!
o Remove the grate from the container. Clean the grate with the wash brush in a warm
water with mild cleaning agent and rinse it under running water.
o Open the drain taps (device code-no. A120466) by lifting the drain safety lock
upwards and turning the lever towards the front. Drain the water out of the
containers via the drain taps to a jug. Place the jugs on a firm surface to avoid
the water to splash.
o From the container of the device code-no. A120465 drain the water out to
a jug or sink.
o Due to hygiene reasons, clean the containers twice a day. Clean the containers
with warm water and mild detergent. Rinse with clean water and dry thoroughly.
- 30 -