Publicité
Les langues disponibles
Les langues disponibles
Original Instruction Manual
En
Flange arrangements
Vibrating discs must be replaced immediately.
Please always keep other persons and combustible material from work area.
Please always make sure work with guard and disc in position before start the
machine.
Removing disc
To remove the disc, press the spindle-lock button in deep and hold it in this position
continuously. If necessary, turn the spindle slightly with the free hand until it locks into
position.
Loose the flange with the spanner provided and then remove the disc from spindle.
CAUTION!
Check the diameter of disc regularly during use. If it is less than 125mm, replace it!
On/Off switch
The machine can only be started by pressing the switch-lock first to prevent any
unintentional operation.
Keep holding ON/OFF switch for continuous operation.
To switch the machine off, release the On/Off switch
CAUTION! Always carry out a test run before starting work and after every tool change!
Always ensure that the tools are in good condition, correctly mounted and able to turn
freely. The trial run should be at last 30 sec.
Working advice
After heavily straining the power tool, continue to run it at no-load for several minutes to
cool down the grinding tool.
Discs become very hot while working; do not touch until they have cooled.
Don't use the machine near inflammable materials, the flying sparks are very hot and
could cause fire or personal injury.
Please always make sure grinding disc touch with workpiece at approximately 15° to
30º and move slowly.
10
10/2016
Publicité
