Sd Memory Card Slot; Power Supply Connection; Vbus ® Connection; Accessing The Dl3 Datalogger Over The Internet With The Vbus.net Visualisation Portal - Resol DL3 Manuel

Adjustment channel Adjustment range / selection
--Auto configuration Yes, No
--Add.
--Mask
--Recover IP Yes, No
--Interval 00:10 ... 24:00
--Recover Now
Erase
-Erase data Yes, No
-Reset Yes, No
Version
5.8

SD memory card slot

SD memory card slot
The SD memory card slot  is located at the front of the device. By means of the
SD memory card slot, logged data can be transferred onto an SD card.
Note:
The memory of an SD card in the slot is used for data transfer only. It will
not enlarge the memory of the DL3 Datalogger.
5.9

Power supply connection

Power supply is carried out via an external mains adapter. The connection terminals
are located inside the housing of the DL3 Datalogger.
Factory setting
Yes
No
No
No
Datalogger DL3

5.10 VBus connection
®
The DL3 Datalogger is connected to one or several RESOL controllers via VBus
cables. The connection terminals are located inside the housing of the DL3 Data-
logger.
6 Accessing the DL3 Datalogger over the Internet
with the VBus.net visualisation portal
The DL3 Datalogger can be easily connected to VBus.net.
Note
In order to use VBus.net for accessing the DL3 Datalogger, Internet access
has to be enabled.
Note
In order to enable VBus.net access, the Datalogger must have unconditional
access to the ports 80 and 1194 / 1195.
In order to access a DL3 Datalogger via VBus.net, proceed as follows:
Î Activate VBus.net in the DL3.
Î Note down the alphanumeric 8-10-digit code (Access Token) indicated on the
display of the DL3.
Î Enter VBus.net into the address bar of the browser and click Sign up.
Î Wait for the confirmation e-mail to arrive.
Î Click Add new device.
Î Enter the alphanumeric 8-10-digit code (Access Token).
www
33
®