Configuration - Resol DL3 Manuel

5.4.3 VBus display
®
In the VBus display, VBus information about the VBus
® ®
dicated.
In the left-hand area of the display, the number of bytes received (Rx) is indicated. In
the right-hand area of the display, the number of bytes transmitted (Tx) is indicated.
A VBus ® device connected with a functioning VBus
a corresponding filled checkbox in the bottom area of the display.
Each VBus device has its own display. The connections VBus
®
displayed each in their own display.
Î In order to leave the status level and access the VBus
Î The display indicates information about the VBus
Î In order to access information about further VBus
pressing button .
5.4.4 Sensor display
In the sensor display, information about the sensors connected is indicated.
In the left-hand area of the display, the resistance value of the corresponding sen-
sor is indicated. In the right-hand area of the display, the temperature value of the
corresponding sensor is indicated in °C.
A sensor connected is indicated by a corresponding filled checkbox in the bottom
area of the display.
Each sensor has its own display. The data of the inputs CL and S1 to S3 are displayed
each in their own display.
Î In order to leave the status level and access the sensor displays, press button .
Î Press button  to scroll down through the VBus
displays appear.
Î In order to access information about further sensors, scroll down by pressing
button .
28
devices connected is in-
®
® communication is indicated by
1 to VBus 6 are
® ®
displays, press button .
®
® device.
devices, scroll down by
®
® displays until the sensor
5.4.5 Heat quantity display
Display of the heat quantity produced. For this purpose, the heat quantity measure-
ment option has to be activated. The accumulated heat quantity can be set back
to zero. For information about adjusting the heat quantity measurement, see 5.5.4
HQM on page 29.
5.5

Configuration

In the Configuration menu, different adjustments can be made.
Î In order to access the menu, press button  for approx. 3 s.
Menu structure
The menu consists of the following sub-menus:
• Language
• Time
• VBus
• HQM
• Sensors
• Logging
• Network
• Erase
• Version x.x
Î In order to access the adjustment mode of a sub-menu, select the desired sub-
menu by pressing buttons  and , and confirm with button .
5.5.1 Language
In the Language sub-menu, the menu language can be selected.
Î Select the desired language by pressing buttons  and .
Î Briefly press button  to confirm the selection.
Î In order to get back to the Configuration menu, select Back and confirm
by pressing button .