Motorised Unit Bottom Fitting; Adjusting Sections; Fixing The Sail Feeder - Facnor HF700 Notice De Montage

4.9- MOTORISED UNIT BOTTOM FITTING

S
R
T
U

4.10- ADJUSTING SECTIONS

Tighten the backstay to put some tension onto the forestay. Leave the feeder piece resting on
the drum. Raise all of the sections together until they touch the top terminal of the forestay.
Insert a screw into one of the lower holes of the last section.
BEWARE: DO NOT OVERTIGHTEN IT
sections slowly descend until a hole coincides with the first of the threads on the telescopic
section.
top
50 mm

4.11- FIXING THE SAIL FEEDER

Enrouleurs hydrauliques FACNOR
Fix the turnbuckle with the pin (Fig. T).
Set up the two half Stainless Steel base (Fig.
R) and block the pin with the two locknuts
(Fig. U)
Lightly grease provided screws (Fig. S). Fix
the top of the Stainless Steel base (Fig. R) to
the motorized unit with the provided screws
(Fig. S).
U
. Press the screw with your thumb and let the
IMPORTANT :

Make sure that sections have descended at least 50mm
before the screw slots into place. Otherwise, proceed to the
next hole, 100mm below.

Leave a margin of at least 50 mm between the halyard
deflector and the bottom of the forestay top terminal.

The ideal position of the feeder is between 600 and 800
mm above the drum shackle.
top
Align holes in the telescopic section with holes in
the feeder. Then, screw down the feeder with the
screw provided.
code /part No document: 29160050159 –
-
R
Chain plate
rev 2018 - page 23/25