Motorised Unit Bottom Fitting; Adjusting Sections - Facnor EF+550-600 Mode D'emploi

4.9- MOTORISED UNIT BOTTOM FITTING

x4
Q
R
2

4.10- ADJUSTING SECTIONS

Tighten the backstay to put some tension onto the forestay. Leave the feeder piece resting on
the drum. Raise all of the sections together until they touch the top terminal of the forestay.
Insert a screw into one of the lower holes of the last section.
BEWARE: DO NOT OVERTIGHTEN IT
sections slowly descend until a hole coincides with the first of the threads on the telescopic
section.
top
50 mm
1
R
4
IMPORTANT :

Make sure that sections have descended at least 50mm
before the screw slots into place. Otherwise, proceed to the
next hole, 100mm below.

Leave a margin of at least 50 mm between the halyard
deflector and the bottom of the forestay top terminal.

The ideal position of the feeder is between 600 and 800
mm above the drum shackle.
code /part No document: 29160050073 - indice A – page 25/29
5
3
6
cadène pont
. Press the screw with your thumb and let the
Q x4
S
7
8
T
x3