Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.3- FITTING THE HALYARD SWIVEL
top
Long U shackle
4.4- ASSEMBLING FOIL SECTIONS
top
H
4.5- FITTING THE TELESCOPIC SECTION
top
I
Ensure you fit the halyard swivel the right way up. Fix the
two shackles. In order to raise the sections as high as
U shackle
possible, we recommend that you fit the halyard swivel
and raise everything by way of a halyard.
IMPORTANT : Be sure to attach a down haul line
to the halyard swivel so as to be able to recover it
bow shackle
later.
The top section is in place. Assemble a bearing around the
forestay. Slip the next section, already assembled (see
preparing the sections p.4), with the connector pointing
towards the top of the forestay. With the help of the
connector, push the bearing all the way up into the top
section until the connector holes coincide with those of the
top section.
G
Fit both screws (fig. G). then, slowly and firmly tighten the
4 screws (fig. G+H).
Repeat the operation until you reach the last section. DO
NOT FIX ANYTHING TO THE LAST SECTION.
Once the sections have been hoisted as high as possible,
assemble a bearing around the forestay.
Fit the telescopic section and push it up. That way, the
bearing (fig. J) goes into the lowest foil section (Rep. I).
J
K
code /part No document: 29160050073 - indice A – page 23/29
If your forestay requires the use of a 1-meter
section, fit it above the lowest 2-meter section.
BEWARE :
SECTION TO THE FORESTAY AS INDICATED
(fig. K). THE SIDE WITH ONLY ONE HOLE
MUST BE POINTING DOWN.
FIT
THE
TELESCOPIC
Publicité
Chapitres
Table des Matières
