4- Assembly Stages; Assembly Of The Halyard Deflector; Assembly Of The Top Cap And The Top Section - Facnor HF700 Notice De Montage

4- ASSEMBLY STAGES :

4.1 – ASSEMBLY OF THE HALYARD DEFLECTOR*
Female part
top
F

4.2- ASSEMBLY OF THE TOP CAP AND THE TOP SECTION

4.2.1- Slip the stainless steel plate and then the top cap around the forestay. Block the plate
by slipping it into the notches on the cap, designed for this purpose.
4.2.2- Around the forestay, assemble a 1
the bearings together, and give the bottom bearing a quarter turn.
IMPORTANT : These two bearings are now joined.
4.2.3- Put the bearing set into the cap, then give another quarter turn to the bearings.
IMPORTANT : Doing this ensures that the bearings are fixed in place in the top
cap.
4.2.4- Take the top section and fix it snugly into the top cap. If assembly is not possible, give
the bearings a half turn in the cap.
Place the 2 pins into the holes in the top cap and the stainless steel plate. Then, tap them into
the section grooves with a mallet.
The pins are simply used to fix the cap. Therefore, do not hit too hard or you may
damage the cap
Enrouleurs hydrauliques FACNOR
Slip the disk around the forestay, screw pointing up.
Assemble the two half bearings above the deflector disk and
around the forestay, the "female" part of the bearing pointing
up. Fit the bearing into the halyard deflector. Then tighten the
screw (fig. F), which will fix the bearing in place.
st
.
code /part No document: 29160050159 –
-
nd
bearing, then a 2 , the "male" part pointing up. Fit
rev 2018 - page 20/25