Remote Control Programming - Leggett & Platt Premier premium MODELS Mode D'emploi

REMOTE CONTROL PROGRAMMING (1 remote control - 1 base)
Program One Remote to Operate One Base - perform the
following numbered procedure.
STEP 1
Position base on its side.
LEAST TWO PEOPLE ARE RECOMMENDED
FOR HANDLING AND MOVING ADJUSTABLE
Locate the control box, attached to the
BASE.
underside of the base (FIGURE 21).
STEP 2
Using a pointed object, press and hold the
learn button for two seconds (FIGURE 21). The
underbed light will "chirp" once to indicate
base is in pairing mode.
FIGURE 21
LEARN
BUTTON
CONTROL
BOX
STEP 3
Then, within 15 seconds, simultaneously press
the Set 1 and Set II buttons on the remote
control (FIGURE 22). The underbed light will
"chirp" twice to indicate remote control is
paired.
One remote control is now programmed to
operate one base.
CAUTION: AT
SET I
BUTTON
FIGURE 22
NOTE
TO UNPAIR THE REMOTE(S), USING A POINTED
OBJECT, PRESS AND HOLD THE LEARN BUTTON
ON THE CONTROL BOX FOR 10 SECONDS.
THE UNDERBED LIGHT WILL "CHIRP" 4 TIMES
WHEN PROCESS IS COMPLETE.
Premier Series
™
SET II
BUTTON
Owners Manual 99301588-b
23