Remote Control Programming - Leggett & Platt performance Queen Manuel Du Propriétaire

STEP 4
Press the head down button on the remote control until the head
section is flat, then press the foot down button on the remote
control until the foot section is flat (FIGURE 14).
FIGURE 14
HEAD
DOWN
BUTTON
STEP 5
Remove two (2) 9 volt batteries from power brick. Plug power cord
back into electrical power source (FIGURE 15). When power is
restored from outage, base is ready to resume normal operation.
FIGURE 15
18
Performance Models Signature Owners Manual 99301468-b
POWER DOWN OPERATION
FOOT
DOWN
BUTTON