Power Down Operation - Leggett & Platt performance Queen Manuel Du Propriétaire

To lower the base to the flat position during an electrical power outage, complete the following procedure:
STEP 1
Verify power is unplugged from electrical power source.
STEP 2
Locate (1) power brick (FIGURE 12) and (2) 9 volt batteries (not
included).
FIGURE 12
POWER
BRICK
STEP 3
Install (2) 9 volt batteries in power brick (FIGURE 13).
FIGURE 13
UNDERSIDE OF
POWER BRICK

POWER DOWN OPERATION

INSTALL (2) 9 VOLT BATTERIES
*BATTERIES NOT INCLUDED
Performance Models Signature Owners Manual 99301468-b
BATTERY
COMPARTMENT DOOR
(push down and slide off
to remove)
17