Remote Control Programming - Leggett & Platt STYLE FOUNDATION DESIGN S-122 Manuel Du Propriétaire

REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
STEP 1
Plug base into power outlet.
STEP 2
Simultaneously press and hold both the HEAD
DOWN and FOOT UP buttons on the remote control
(FIGURE 5). While holding these buttons, press and
hold the LEARN button on the control box (FIGURE
6) or the PAIR button on the in-line switch (FIGURE
7), as equipped. Hold until you hear an audible
sound, then release all buttons.
FIGURE 5
HEAD
DOWN
FIGURE 6
FOOT UP
LEARN
BUTTON
CONTROL BOX
FIGURE 7
ELECTRICAL
POWER CORD
Note: Your base may be equipped with an in-line
switch (pair button) as part of the electrical power
cord located near the end of the power cord. This
can be used in lieu of the learn switch on the
control box.
STEP 3
Operate the remote control to verify the base
functions correctly.
PAIR
BUTTON
IN-LINE
SWITCH
11