Leggett & Platt STYLE FOUNDATION DESIGN S-122 Manuel Du Propriétaire page 7

STEP 2
Set the hardware box aside. Cut the zip-tie and
remove the mattress retainer.
STEP 3
Plug electrical power cord into power brick.
Plug brick power cord into base motor cable.
Secure connection using cable latch (FIGURE
1). Note: Align pins before inserting plugs.
FIGURE 1
POWER BRICK
INSERT
ELECTRICAL
POWER CORD
HERE
STEP 4
Screw the legs into the tapped holes at the (4) corners
(FIGURE 2).
FIGURE 2
Push pin in to
adjust leg height
(6 inches to
10 inches).
ASSEMBLY
POWER BRICK CORD
(ATTACH TO BASE
MOTOR CABLE)
PIN
WARNING
!
POWER CORDS MUST NOT INTERFERE WITH
ANY ADJUSTABLE BASE MECHANISMS.
DO NOT WEAVE CORDS THROUGH BASE
STRUCTURE.
IN-LINE SWITCH /
PAIR BUTTON
MOTOR
CABLE
Note: Your base may be equipped with
an in-line switch (pair button) as part of
the electrical power cord located near the
end of the power cord. This can be used
in lieu of the learn switch on the control
box.
CABLE
MOTOR
LATCH
CABLE
POWER
BRICK
CORD
CABLE
LATCH
7