Leggett & Platt STYLE FOUNDATION DESIGN S-122 Manuel Du Propriétaire page 12

REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
STEP 1
Plug both bases into power outlet. Operate each base with
its respective remote control to verify the base functions
properly.
Lower both bases to the flat position.
STEP 2
UNPLUG both bases.
STEP 3
Place both bases on their sides close to each other.
CAUTION: DUE TO RISK OF INJURY, TWO ADULTS ARE
REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
STEP 4
Locate the sync cable (FIGURE 8)
FIGURE 8
SYNC CABLE
STEP 5
Plug the ends of the sync cable into the sync port (on the
control box) of BOTH bases (FIGURE 9).
FIGURE 9
12
.
CONTROL
LEARN
BOX
BUTTON
SYNC
SYNC
PORT
CABLE
OR
REMOTE 1 REMOTE 2
STEP 6
Turn both bases over onto their legs.
CAUTION: MAKE SURE SYNC CABLE IS NOT CAUGHT
IN BASE OR PINCH POINTS.
STEP 7
Plug both bases back into power outlet.
STEP 8
Operate the remote control(s) to verify both bases function
correctly. If using only one remote control to operate both
bases, store the second remote for use as a spare.
Note: To revert back to 1-to-1 programming, remove sync
cable from control boxes.
BASE 1
BASE 2