Leggett & Platt Premier premium MODELS Mode D'emploi page 24

REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
Program One Remote to Operate Two Bases (Tandem
Syncing) - perform the following numbered procedure.
STEP 1
Choose base 1 remote. Retain base 2 remote control
as a spare or use if 2 remotes are desired to operate
both bases.
STEP 2
Locate dual sync cable (FIGURE 23).
FIGURE 23
DUAL SYNC
CABLE
STEP 3
Position both bases on their sides, in close proximity
to each other. CAUTION: AT LEAST TWO PEOPLE
ARE RECOMMENDED FOR HANDLING AND
MOVING ADJUSTABLE BASE.
STEP 4
Locate the control boxes on both bases. On base
1, make sure the primary/secondary button is in
the "OUT" position. On base 2, press the primary/
secondary button so it is in the "IN" position
(FIGURE 24).
FIGURE 24
SECONDARY
24
Premier Series Owners Manual 99301588-b
™
PRIMARY/
BUTTON
CONTROL
BOX
OR OR
REMOTE 1 REMOTE 2
STEP 5
Plug one end of the dual sync cable in the CAN/BUS
17 port of the control box of base 1. Plug the other
end of the dual sync cable into the CAN/BUS 17
port of the control box of base 2 (FIGURE 25).
FIGURE 25
DUAL SYNC
CABLE
BASE 1
BASE 2
CAN/BUS
17 PORT
continued on next page...