Publicité
Les langues disponibles
Les langues disponibles
V1.0
PROBLEM
Tool will not run.
Air flows freely
from exhaust.
Tool will not
shut off.
Loss of power
or erratic
performance.
NOTE: Repairs should be carried out by a qualified technician.
Visit www.princessauto.com for more information
1/2 in. dr. Micro Stubby Air Impact Wrench
POSSIBLE CAUSE(S)
O-rings throttle
dislodged from seat
inlet valve.
O-rings throttle valve
dislodged from seat
inlet valve.
Excessive drain on
the air line. Moisture
or restriction in the
air hose. Incorrect
size or type of
hose connectors.
SUGGESTED
SOLUTION(S)
1. Pour air tool lubricating
oil into air inlet as per
instructions.
2. Operate the tool
in short bursts of forward
and / or reverse rotation
where applicable.
3. Tap the motor housing
gently with
a plastic mallet.
4. Disconnect the air
supply. Free the motor by
rotating the drive shank
manually where
applicable.
5. If the tool remains
jammed, return to service
centre.
Have a qualified
technician replace
the O-ring.
Check the air supply.
If the tool is not
connected to the air line,
connect it properly.
8630972
15
Publicité
