PRO-POINT 8630972 Manuel D'utilisateur page 10

8630972
SOCKET INSTALLATION
Turn off the air compressor and disconnect the air hose when
changing sockets. After attaching the socket, attach the air
hose and turn the air compressor on.
Make sure that the nut or bolt you are using the tool to tighten
is rated for 10,000 RPM or greater. If available, check the
recommended torque specifications of the nut.
1. Select the appropriately sized 1/2 in. drive impact socket
for the job.
NOTE: Only use impact sockets which are specifically
designed for use with an impact wrench. Do not use worn or
damaged sockets.
2. Push and snap the socket (sold separately) onto the anvil.
OPERATION
WARNING! This tool generates considerable torque when in
use. Always hold the tool securely when using, and brace
yourself to resist the torque which will be delivered to the
work piece.
1. Tighten the nut as far as you can by hand before using the
air impact wrench.
2. Connect the air impact wrench to the air hose.
3. Place the socket on the nut and grip the air impact
wrench tightly. Squeeze the trigger to activate the tool
in clockwise rotation.
NOTE: For reverse (counterclockwise) rotation, turn the
reversing switch located on the back of the tool to activate
the reverse rotation.
10
1/2 in. dr. Micro Stubby Air Impact Wrench
For technical questions call 1-800-665-8685
V1.0